A forum for everything that Kinda Works YouTube.com/ItKindaWorks
You are not logged in.
Offline
Hey,
I was wondering if the reading on the serial monitor for current is in milliamperes or in amperes?
Last edited by Yadnyesh (2018-02-05 07:47:49)
Offline
Hi,
I just saw your video and I also want to make the same project for my home. I'm still planning to buy the hardware and stuff so before I buy I would like to ask if I can only use the ESP8266 NodeMCU only without the teensy board?
I'm planning to use only the ESP8266 nodeMCU to get the voltages, ams, watts and also use the same board to access MQTT, is that possible?
Thanks in advance!
Offline
I just found out that nodeMCU only have one analog input. I'm now using a nano and got the current meter running but I still have to calibrate it though. I don't have a kill a watt at the moment. Planning to buy a current clamp meter.
Again, I really appreciate your video and I learned a lot from it. I'm not really a hardware guy and right now I'm learning a bit of hardware stuffs. Thanks to you!
Offline